How to reset Barcode Scanner to use Stocktake tool?

Our Stocktake tool works on a web browser and follows the keyboard mode, a different mode from what allows the scanner to work for our iOS App.
 
Here’s how to use Barcode Scanner for Stocktake Tool:
 
  • Turn off scanner to disconnect from your iOS device.
  • In your iOS device, go to Settings > Bluetooth > click “Forget this device”.
  • Turn on scanner and enable Keyboard mode by scanning the Barcode below.
HID.png
  • Go back to Settings > Bluetooth > connect your Barcode scanner.
 
Repeat the same steps above if you wish to switch back to iOS mode or use TradeGecko's Mobile Sales App, except you will scan this Barcode instead:
 
iOS.png
 
 
 
Note
You may need to print the Barcodes, if you are unable to scan it from the screen.
 
Print Friendly Version of this pagePrint Get a PDF version of this webpagePDF
Have more questions? Submit a request
Was this article helpful?
0 out of 0 found this helpful

Comments

NEW TO TRADEGECKO? START A 14 DAY FREE TRIAL, NO CREDIT CARD REQUIRED